Commands
FTP commands
- LIST — List contents of the supplied directory (or user’s FTP root)
- PASS — Specify the password for the account logging on
- PASV — Switch to passive mode
- QUIT — End the current session/connection
- RETR — Retrieve the provided file
- STAT — Provide connection/server information
- SYST — Provide system “type” information
- TYPE — Switch between ASCII (A) and binary (I) transfer modes
- USER — Specify the username for the account logging on
There are a lot more obscure commands as well, though the above is sufficient for basic operations.
Link to original
File transfers
How to transfer files over FTP using netcat
Note that you cannot receive files using FTP with a single telnet/netcat session, as file transfers are conducted over a separate channel (either a channel originating from port 20 on the server for “active” mode or a random port above 1023 on the client for “passive” mode).
However, you can retrieve files using two sessions.
- Switch to passive mode (PASV).
- The FTP server will reply with a string of the form (o1,o2,o3,o4,p1,p2), where o1 – o4 are the four octets of the server’s IP address and p1 – p2 are the high + low bytes of the port number to connect to.
- Use (256 × p1) + p2 to determine the decimal port number. For example, if p1 = 117 and p2 = 85, then then port number you need to connect to is 30037.
- Connect a second telnet/netcat client to the IP + port provided by the server.
- Issue the appropriate file retrieval (RETR) command in the original telnet/netcat client. The file will be sent to the second client.
Which is a lot of work, but sometimes you just don’t have an FTP client.
Link to original
FTPS
FTPS
FTPS (FTP over SSL) uses port 990 by default. Mostly supplanted by SFTP.
Link to original
ftp binary shell escape
ftp (application)
If the ftp binary can be run with NOPASSWD via sudo, then you can break out into a root shell using
Link to original!/bin/sh.